3D Printed Car Belt | Will It Run?

I don’t know why the thought occurred to me, but I had to know if my car engine would run on a 3D printed serpentine belt. I modeled my serpentine belt in Fusion 360 and then printed it out on it’s side with flexible filament.

The end result was surprisingly strong but not very pretty. I think all of the inaccuracies in the print led to it jumping around on the pulley. This belt was used to drive the alternator and water pump, so even if it fails it won’t be catastrophic for the engine…hopefully.

Fusion 360 For Hobbyist and Woodworkers Video Course:
http://mikeandlauren.com/Fusion360Masterclass

Leave a Reply

Your email address will not be published. Required fields are marked *