Mike Makes a Cable Ramp for Power Cords

I now have a table saw, router table, and X-Carve all in the middle of my shop. Up until now, I’ve just run extension cords whenever I needed power. Today I changed that!

I copied the commercially available cable ramp/cord management design, but I made it out of wood. I could have done everything on the table saw, but I wanted to experiment with the X-Carve so I made them modular.

Now I can add or subtract as many pieces as I want to change the length. It turned out great!

X-Carve Info: http://www.inventables.com

2 thoughts on “Mike Makes a Cable Ramp for Power Cords

Leave a Reply

Your email address will not be published. Required fields are marked *